Benefits & Features: The body meets strict 3-A Sanitary Standards using the new "Third Party Verification" (TPV) program; Internals are machined or polished to meet 3-A self-draining and cleaning requirements (Ra32); CIP, SIP, COP; High Accuracy: ± 0.5% (Linearity); Field Serviceable; 6 Digit Display - Floating Decimal; Rate of Flow; Batch & Cumulative Totals; Factory Calibrated and Field Calibratable; Choice of Gallons or Liters; Custom Programmable Display (including UOM)

Max Pressure Drop (at Max Flow in test conditions): 14 PSI

Accuracy (% of Reading) Factory Calibrated with Computer: ± 0.5%

Repeatability (based on test conditions): ± 0.1%

Recommended Strainer Size: 18 Mesh (1000 Microns)

Max. Particle Size: .039" / 1.00 mm

Maximum Viscosity: 100 cps<br>[For viscous fluids like oils, the temperature must not fluctuate more than ±5°F to avoid accuracy fluctuations]

Operating Temp Without Local Computer or With Remote Computer: -100 to 225°F (-74 to 107°C)<br>[SIP (Up to 1 hour) 285°F (140°C). Remove pickup, gaskets & clamps not rated to 285°F]

Bearings: PEEK

Shaft: 316SS

Thrust Bearings: PEEK

Rotor: CD4MCu Stainless Steel (Nickel Plated)

Rotor Supports: 316SS

Signal Generator: Not Wetted

Retaining Rings: 302SS/316SS

Display Function: Rate + 2 Totals (1 Resettable, 1 Cumulative)

Local Computer Calibrations: Factory & Field

LCD Digits: 6

Totalizing Display Starting Increment: 0.01

Totalizing Resets to 0 After Reaching: 99999999

Typical K-Factor PPG (PPL): 342

Local Module & Output Signal: NPN transistor, scalable

Sensor (Pickup): Magnetic

Battery Power: 3.6V Battery (~2 year life)

External Power: Regulated 8-24VDC (Recommended)

Frequency Range: 100 - 1000 Hz (Universal pulse/frequency input compatible with Reed switch, Hall effect, Namur proximity detectors, voltage, current & Coil (15mV P-P min). Max. input frequency 5Khz under external power. The maximum input frequency when not externally powered is 150hz.)

Remote Output: (Pulse Out)

Application Notes: See page 5 in the manual for 3-A Recommended Practices. Unidirectional. The line must be full (no air) for proper accuracy. NOTE: External Power is required for the backlit display and for the meter to function properly at its maximum flow rate. While the display will function under battery power only, the maximum input frequency is too low unless it is externally powered. When maximum flow rates exceed 1 kHz (1000 Hz), external power must be used. See the Frequency Range notes.

Piping Notes: If pump, valve, etc. is upstream, need min. 20" Upstream

Connection to Connection Length (OAL): 4.594" (116.7 mm)

Shipping Weight (Approximate): 11 lbs (5.0 kg)

Approvals Notes: Only the turbine body is 3-A Approved; See catalog page for full approval specs